MIL-DTL-3432J
TABLE XI. Material inspection.
Material
Requirement paragraph
Applicable specification
Copper
Insulating and
Appendix A, Appendix B,
or ASTM D4066
jacketing compounds
Polyethylene
ASTM D4976, ASTM D1248 or equivalent
Crosslink
Table B-II
polyethylene
Polyamide (nylon)
Fillers and binders
Polyester tape
Polypropylene tape
4.4.1 Reinspection. If the cable is supplied on spools, reels, or coils or in precut lengths and is more than 12
months or 4 quarters of a year old from the date of last inspection to the date of shipment, the cable shall be
inspected again to meet the applicable aging tests of appendices A or B of this specification, or ASTM D4066 for the
insulation and jacket compounds used.
4.5 Inspection conditions. Unless otherwise specified herein, all inspections shall be performed in accordance with
the test conditions specified in the "GENERAL REQUIREMENTS" of FED-STD-228.
4.6 Conformance inspection. Conformance inspections shall consist of group A, B, and C inspections.
4.6.1 Inspection of the product for delivery. Inspection of the product for delivery shall consist of groups A and B.
4.6.1.1 Inspection lot. An inspection lot shall consist of all cables of the same type designation (see 1.2.1)
produced under essentially the same conditions, and offered for inspection at the same time.
4.6.1.2 Unit of product. The unit of product shall be taken as a continuous length of cable contained on a spool,
reel, or coil. The unit of product shall not exceed 5,000 feet on each spool, reel, or coil.
4.6.1.3 Inspection sample. The inspection sample shall be product selected at random from the lot without regard
to quality and shall be of the size specified in table XII.
18
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business