MIL-DTL-28830E
6.2 Acquisition requirements. Acquisition documents must specify the following:
a.
Title, number, and date of this specification.
b.
Title, number, and date of the applicable specification sheet.
PIN (see 1.2.1 ).
c.
d.
Packaging (see 5.1).
e.
Total footage of cable.
6.3 Qualification. With respect to products requiring qualification, awards will be made only for
products which are at the time of award of contract, qualified for inclusion in the Qualified Products
List QPL No. 28830 whether or not such products have actually been so listed by that date. The
attention of the contractors is called to these requirements, and manufacturers are urged to arrange
to have products that they propose to offer to the Federal Government tested for qualification in order
that they may be eligible to be awarded contracts or purchase orders for the products covered by this
specification. The activity responsible for the qualified products list is the Defense Supply Center
Columbus, P.O. Box 3990, Columbus, Ohio 43218-3990, attention VQ and information pertaining to
qualification of products may be obtained from that activity. An online listing of products qualified to
this specification may be found in the Qualified Products Database (QPD) at https://assist.dla.mil.
6.4 Environmentally preferable material. Environmentally preferable materials should be used to the
maximum extent possible to meet the requirements of this specification. As of the dating of this
document, the U.S. Environmental Protection Agency (EPA) is focusing efforts on reducing 31 priority
chemicals. The list of chemicals and additional information is available on their website
https://www.epa.gov/osw/hazard/wastemin/priority.htm. Included in the EPA list of 31 priority
chemicals are cadmium, lead, and mercury. Use of these materials should be minimized or eliminated
unless needed to meet the requirements specified herein (see Section 3).
6.5 Subject term (key word) listing.
Copper
Polyethylene
6.6 Change notations. The margins of this standard are marked with vertical lines to indicate
modifications generated by this change. This was done as a convenience only and the Government
assumes no liability whatsoever for any inaccuracies in these notations. Bidders and contractors are
cautioned to evaluate the requirements of this document based on the entire content irrespective of
the marginal notations.
17
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business