MIL-DTL-28830E
4.7.16 Continuous lengths (see 3.8). Unless otherwise specified in the acquisition requirements
(see 6.2) the inspection requirements for continuous cable lengths shall be satisfied by the
contractor's certificate of conformity and the presence of the required piece length markings on the
spools or reels. However, the Government reserves the right to examine such certified lot if deemed
necessary to assure that the length actually conforms to the requirements. When the acquisition
requirements (see 6.2) specifies examination of cable lengths, the Government representative shall
examine the cable at his own discretion to determine conformity to this requirement. In measuring
continuous cable lengths where marking or stripping of jacket has been used in lieu of cutting the
cable to identify dielectric test failures or areas not properly tested, such marking or stripping shall be
considered equivalent to severance of the cable at the two ends of each marked or stripped area.
4.7.17 Flame propagation (see 3.5.15). Flame propagation shall be tested in accordance with
4.7.18 Acid gas generation (see 3.5.16). Acid gas generation shall be tested in accordance with
4.7.19 Halogen content (see 3.5.17). The halogen content shall be determined as specified in
17.
4.7.22 Tensile strength and elongation (see 3.5.20). Tensile strength and elongation shall be tested
in accordance with MIL-DTL-17.
5. PACKAGING
5.1 Packaging (see 6.2). For acquisition purposes, the packaging requirements shall be as specified
in the contract or order (see 6.2). When actual packaging of materiel is to be performed by DoD or
in- house contractor personnel, these personnel need to contact the responsible packaging activity to
ascertain packaging requirements. Packaging requirements are maintained by the Inventory Control
Point's packaging activities within the Military Service or Defense Agency, or within the Military
Service System Commands. Packaging data retrieval is available from the managing Military
Department's or Defense Agency's automated packaging files, CD-ROM products, or by contacting
the responsible packaging activity.
6. NOTES
(This section contains information of a general or explanatory nature that may be helpful, but is not
mandatory.)
6.1 Intended use. Cables covered by this specification are intended for use in radio frequency
applications.
16
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business