MIL-DTL-25038J
5. PACKAGING
5.1 Packaging. For acquisition purposes, the packaging requirements shall be as specified in the
contract or order (see 6.2). When packaging of materiel is to be performed by DoD personnel or in-
house contractor personnel, these personnel need to contact the responsible packaging activity to
ascertain packaging requirements. Packaging requirements are maintained by the Inventory Control
Point's packaging activities within the Military Service or Defense Agency, or within the military service's
system commands. Packaging data retrieval is available from the managing Military Department's or
Defense Agency's automated packaging files, CD-ROM products, or by contacting the responsible
packaging activity.
6. NOTES
(This section contains information of a general or explanatory nature that may be helpful, but is not
mandatory.)
6.1 Intended use. The basic insulated wire covered by this specification is intended for use in circuits
in high performance military aircraft where it is necessary to maintain the electrical integrity of the
insulated conductor for 15 minutes in a 2,000 °F flame, with the operating potentials not exceeding
125 V rms.
6.2 Acquisition requirements. Acquisition documents should specify the following:
a. Title, number, and date of this specification.
b. PIN (see 1.2).
d. Wire length (see 6.3).
6.3. Wire length. No less than 85% of the total quantity of each size of wire ordered will be in lengths
equal to or greater than the nominal length specified in table VI. No wire will be accepted in lengths
shorter than the specified minimum acceptable length. The maximum quantity of wire in a single length
will be limited only by manufacturing and handling facilities.
19
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business