MIL-DTL-24640C
TABLE XIII. Conformance inspection - Continued.
Examination or test
Requirement paragraph
Test method paragraph
Group B:
Cold bending
Specification sheet
Cross link proof
Specification sheet
Drip
Specification sheet
Tear strength
Specification sheet
Physicals (unaged)
Specification sheet
Attenuation
Specification sheet
Gas flame (1 hour)
Specification sheet
Group C:
Physicals (aged)
Specification sheet
Permanence of printing
Specification sheet
(conductor insulation)
Permanence of printing (jacket)
Specification sheet
Heat distortion
Specification sheet
Cable sealant removability
Specification sheet
Shrinkage
Specification sheet
Surface transfer impedance
Specification sheet
Group D:
Flame propagation
Specification sheet
4.4.1 Inspection lot. An inspection lot shall consist of the total number of units of product of any one type,
size, and construction manufactured under essentially the same conditions.
4.4.2 Basic electrical tests. Basic electrical tests shall be in accordance with the applicable specification sheet
and shall be performed on each length of completed cable. For electrical test purposes, length of completed cable
shall be as defined in 6.7.4.1.
4.4.3 Sampling procedure. The required number of samples (see 4.4.3.1 through 4.4.3.4) for Groups A, B, C,
and D examination and tests shall be selected at random from the inspection lot. Nonconforming starting and
finishing ends of cable shall be removed by the manufacturer prior to selecting samples.
4.4.3.1 Sampling for group A examination and tests. Samples for Group A examination and tests shall be
selected from each lot as specified in table XIV.
19
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business