MS25471F TABLE III. Dimensions.
Inches |
mm |
Inches |
mm |
Inches |
mm |
Inches |
mm |
.005 |
.13 |
.074 |
1.88 |
.163 |
4.14 |
.360 |
9.14 |
.007 |
.18 |
.085 |
2.16 |
.176 |
4.47 |
.384 |
9.75 |
.010 |
.25 |
.093 |
2.36 |
.193 |
4.90 |
.425 |
10.79 |
.015 |
.38 |
.095 |
2.41 |
.218 |
5.54 |
.432 |
10.97 |
.033 |
.84 |
.110 |
2.79 |
.248 |
6.30 |
.460 |
11.68 |
.041 |
1.04 |
.125 |
3.18 |
.272 |
6.91 |
.490 |
12.45 |
.052 |
1.32 |
.128 |
3.25 |
.303 |
7.70 |
.535 |
13.59 |
.060 |
1.52 |
.143 |
3.63 |
.345 |
8.76 |
.585 |
14.86 |
REQUIREMENTS
The procurement specification for this specification sheet is MIL-DTL-8777. Dimensions are in inches.
Metric equivalents are given for information only.
Tensile strength (minimum): 800 psi before aging; 600 psi after aging.
Elongation (minimum): 1.5 inches (38 mm) [ 2 inch (51 mm) specimen stretched to 3.5 (89 mm) inches]
before and after aging.
Insulation shrinkage: During and following the thermal shock or flash test, the primary insulation shall not shrink greater then .060 inch (1.52 mm) for all wire sizes.
Dimensions and configuration: See figure 1 and tables I, II and III.
Part or Identifying Number (PIN) example: MS25471 - 10
MS specification sheet number
Dash number
Changes from previous issue. Marginal notations are not used in this revision to identify changes with respect to the previous issue due to the extent of the changes.
Referenced document. This document references MIL-DTL-8777.
CONCLUDING MATERIAL
Custodians: Preparing activity: Army - AV DLA - CC
Navy - AS
Air Force - 85 (Project 6145-2011-032) DLA - CC
NOTE: The activities listed above were interested in this document as of the date of this document. Since organizations and responsibilities can change, you should verify the currency of the information above using the ASSIST Online database at https://assist.daps.dla.mil.
3
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business