MIL-DTL-915/48D
Group B:
Attenuation - at 3 MHz, db/100 feet, maximum...................................................................................3
Cold working (minus 54 ± 2°C)........................................................................................... No damage
Drip - at 75 ± l°C............................................................................................................................. Zero
Physicals (unaged)
Insulation (conductor)
Tensile strength - lbf/in2, minimum ....................................................................... 1400
Elongation - percent, minimum ............................................................................... 300
Jacket (cable)
Tensile strength - lbf/in2, minimum ....................................................................... 1800
Elongation - percent, minimum ............................................................................... 300
Set - inch, maximum ................................................................................................. 3/8
Group C:
Physicals (aged)
Insulation (conductor)
Air oven
Elongation - percent of unaged, minimum................................................... 60
Permanence of printing (jacket) - cycles, minimum ....................................................................... 250
Cable filler removability ........................................................................................................ No failure
Shield-conformance to material coverage and construction ................................................. No failure
QUALIFICATION INSPECTION:
Qualification inspection shall include basic electrical, all of groups A, B and C, plus the following:
Cable aging and compatibility (95 ± 3°C) ................................................................ No failure
Cold working (minus 54 ± 2°C) ................................................................................ No failure
UNIT ORDERING LENGTH:
All sizes 1000 feet (nominal).
PART OR IDENTIFYING NUMBER (PIN): The PIN consists of the letter M, the general
specification number along with the specification sheet, and a dash number representing type and
size. Refer to MIL-DTL-915 for an example.
M
915
/48-
X-X
Type and Size
Prefix for
Specification
Specification
Number
Sheet
Military
Specification
Number
CHANGES FROM PREVIOUS ISSUE: Marginal notations are not used in this revision to
identify changes with respect to the previous issue due to the extent of the changes.
3
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business