INCH-POUND
MIL-DTL-24640/14E
8 November 2011
SUPERSEDING
MIL-DTL-24640/14D
22 August 2002
DETAIL SPECIFICATION SHEET
CABLE, ELECTRIC, -20 TO +105 °C, 600 VOLTS, LIGHTWEIGHT,
MULTI-CONDUCTOR, 22 AWG, TYPE 1XSOW
This specification is approved for use by all Departments and Agencies of the Department of Defense.
The requirements for acquiring the product described herein shall consist of this specification sheet and
MIL-DTL-24640.
Construction (Watertight)
First
7-strand, tin-coated copper conductor. AWG size and dimensions in accordance with
-
table I.
Second
Insulation material and basic construction requirements shall be in accordance with
-
SAE-AS81044/12, and tested in accordance with the component wire ratings and
requirements listed on this specification sheet. Conformance testing shall be in
accordance with SAE-AS81044 prior to cabling. Component wire color shall be white,
unless specified otherwise.
Third
Braided shield of 38 AWG tin-coated copper strands. Braid coverage shall be no less
-
than 90 percent determined in accordance with WC-27500.
Fourth
Shield insulation of two polyester tapes or a polyester tape and extruded jacket.
-
Identification codes applied using Method 2.
Fifth
The required number of shielded components shall be cabled together. Cabling sequence
-
shall be consecutive, starting with number 1 from center outward. Fillers may be used, as
necessary, to form a round cable.
Sixth
Optional binder tape.
-
Seventh
Braided shield, tin-coated copper strands. Braid must be constructed to meet surface
-
transfer impedance requirements as listed herein.
Eighth
Optional binder tape.
-
Cross-linked polyolefin jacket (see table II for thickness).
Ninth
-
NOTE: Manufacturer's identification tape or thread is required (see 3.7.3).
AMSC N/A
FSC 6145
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business