INCH-POUND
MIL-DTL-24640/13E
8 November 2011
SUPERSEDING
MIL-DTL-24640/13D
22 August 2002
DETAIL SPECIFICATION SHEET
CABLE, ELECTRIC, -20 TO +105 °C, 600 VOLTS, LIGHTWEIGHT,
MULTI-PAIR, 26 AWG, TYPES 2XSXO AND 2XSXOW
This specification is approved for use by all Departments and Agencies of the Department of Defense.
The requirements for acquiring the product described herein shall consist of this specification sheet and
MIL-DTL-24640.
Construction, Non-Watertight (2XSXO) and Watertight (2XSXOW)
First
19-strand, tin-coated copper conductor, 26 AWG.
-
Second
Component wires shall be SAE-AS81044/12, except identification shall be in accordance
-
with the codes and methods of MIL-DTL-24640. Testing shall be in accordance with the
component wire ratings and requirements listed on this specification sheet. Conformance
testing shall be in accordance with SAE-AS81044 prior to cabling.
Two conductors, one black and one white, twisted together. The pitch shall be ¾±⅛
Third
-
inch.
Fourth
Optional binder tape.
-
Fifth
Braided shield of 38 AWG tin-coated copper strands. Braid coverage shall be no less
-
than 90 percent determined in accordance with WC-27500.
Sixth
Shield insulation of two polyester tapes or a polyester tape and extruded jacket.
-
Identification codes applied using Method 2.
Seventh
Four shielded pairs shall be cabled together. Cabling sequence shall be consecutive.
-
Fillers may be used, as necessary, to form a round cable.
Eighth
Optional binder tape.
-
Ninth
Braided shield, tin-coated copper strands. Braid must be constructed to meet surface
-
transfer impedance requirements as listed herein.
Tenth
-
Optional binder tape.
Cross-linked polyolefin jacket (see table I for thickness).
Eleventh
-
NOTE: Manufacturer's identification tape or thread is required (see 3.7.3).
AMSC N/A
FSC 6145
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business